[Gelöst] Patch 1.1.1

 system environment

• Windows 25H2
• Bitwig 6 Beta V15
• VST 3
• Reecer-Version 1.1.1

Error description

Sub

• Sub now seems to run through OSC A amp ADSR and seems to be a saw

Modulation

• LFO 1,2&3
• When Sync is active LFO rate knob no longer seems to work (I think it’s at max rate)
• Rate works as expected when sync is off
• Saw up and down both seem to go up (mod set to 1 on both)

LFO 1 Source to target) MOD set to 1.0:

Oscillator Section targets

• F1 Reso cause audio to stop (does not resolve when switching preset requires plugin reload
• F2 Reso cause audio to stop (does not resolve when switching preset requires plugin reload

Filters section

• Flt Mix appears to work no visual feedback on the knob
• Flt drive does not appear to work

Macro Section

• Appears to work on 1-4 but no visual feedback on the knobs

Synth Panel

• Phase appears to work no visual feedback on the knob
• Formant A (should be vowel A) no visual feedback on the knob
• No target for Vowel B

Drive Slots

• Drv1 Amt does not appear to work
• Drv1 Mix does not appear to work
• Drv2 Amt does not appear to work
• Drv2 Mix does not appear to work
• Drv3 Amt does not appear to work
• Drv3 Mix does not appear to work
• Drv3 Amt does not appear to work
• Drv3 Mix does not appear to work

Chorus

• Targets seem to work but no visual feedback on the knobs

Phase

• Targets seem to work but no visual feedback on the knobs

Drive Tab

By static crackle I mean like the sound of a bad connection/cables/electronic interference

• Soft Clip amount 0 mix 100 unpleasant Static crackle
• Hard clip amount 0 mix 100 unpleasant Static crackle
• Tube amount 0 mix 100 unpleasant Static crackle
• Fold amount 0 mix 100 unpleasant Static crackle
• Asymmetric amount 0 mix 100 unpleasant Static crackle
• Bit crush amount 0 mix 100 unpleasant Static crackle
• Warmth amount 0 mix 100 unpleasant Static crackle (less than the above)
• Tape Saturation amount 0 mix 100 unpleasant Static crackle (same as Warmth)
• Valve Drive amount 0 mix 100 unpleasant Static crackle
• Diode Clip amount 0 mix 100 unpleasant Static crackle
• Exciter amount 0 mix 100 unpleasant Static crackle (less than the above)
• Brutal Distortion amount 0 mix 100 unpleasant Static crackle
• Harmonic enhancer amount 0 mix 100 unpleasant Static crackle (less than the above)
• Metal Zone amount 0 mix 100 unpleasant Static crackle
• Vintage Fuzz amount 0 mix 100 unpleasant Static crackle

That’s all I had time for back at work now progress will be a little slower till the weekend

Additionally helpful

• RME baby face Pro FS buffer 1024